Install Wall Tile Like A Pro

"Closing out Sale...50% Off on All Items!" The streamer on your favorite hardware made you think of finally doing the bathroom redecorating project that you have been putting off for quite sometime. Finally you will be able to install wall tile in your bathroom due to the lower cost of the tile.

A ceramic wall tile would brighten the unfinished wall of your bathroom. A porcelain or ceramic tile is moisture and stain resistant making it an ideal material for bathrooms, backsplash and countertops and in other areas frequently exposed to water.

Basically the procedure to install wall tile is the same with the method for installing floor tiles. You can even say that wall tile is a lot easier to install as you won't need to cut tiles to fit the curves and corners of fixtures. Although the procedures are quite the same, a different kind of tile is needed for a bathroom wall.

A nonvitreous tile is one that absorbs more water. This kind of tile is most suited for floors. A simivitreous tile is suited for backsplash areas as these tiles have low water absorption quality. For the bathroom tile you have to choose one that is high in density to avoid water seepage. Non-moisture absorption will ensure that the appearance of the tile as well as the over all looks of the bathroom will remain the same for a long time. Here are the tips:

• To install wall tile like a pro you have to prepare the surface. Ensure that the wall to be tiled is clean, flat and most importantly can hold the weight of the tile. You won't have a problem with the weight of the tile if you have to cover a concrete wall but if not you have to mount a Ѕ" cement wall board.

• Layout is important to install wall tile symmetrically. To ensure that the pattern is square, snap chalk lines. This will be your guide to install the tile. Most bathroom tiles do not cover the entire wall. It is necessary to chalk a line where the installation will end.

• To create a more appealing bathroom wall you may opt to install wall tile with decorative borders. Now these patterned tiles would need you to exert careful attention to details to ensure that the designs and patterns are aligned.

• Although walls are relatively free surface, there is still a need to cut tiles when you reached the last row. Use a wet saw with a diamond blade to cut the tiles like the pros do. This will ensure a clean, smooth cut. If a wet saw is not available, you can use a tile nipper to cut small pieces of the tile until the mark is reached. Smooth the edge of the tile with sand paper.

• Apply the thin set using a plain edged trowel. Starting from the bottom, set the tiles working upwards. Once all the tiles are installed, set for about two days after which you can now apply the grout. The project is done!

A home make over is a costly project but with the offered discount plus the savings you will have by doing the project yourself, for sure you will be able to buy the more expensive and stylish ceramic tile.

If you would like to learn more before you start your project so you are totaly prepared. Then you need to CLICK HERE to learn what you need to do. Article Source: http://EzineArticles.com/?expert=Phil_Rorrer